Monday, May 25, 2009

Cage Fabrication

Sarted the cage install - rear hoop now welded in - fixed some 6mm angle/plate down the heel board so really solid mounting - going to run the front cage and triangulate down to the front chassis outriggers





Longitudinally brace down to the gearbox area and back down to the rear deck






Really got some amps into the 48mm O/D seamless tube and plate - takes ages to 'birds mouth' all the connecting links

















Solid as a rock - will plate across to the tub aswell to give it even more rigidity - much better than that bolt in off the shelf crap you buy with an FIA approved sticker - know what I'd rather be in if it rolls over!!!!



Tuesday, May 12, 2009

Project floor pan - strengthening and areo dynamics

Looking now at fabricating a complete ally under pan - which will cover floor and chassis from front cross member to rear valance

Tooks some intial dimensions and will overlay images in AutoCAD to make a 1:1 template - then dxf it out to take down to the water jet cutter


Only problem is when the drives side floor pan was lowered by 1'25'' to well in the pan (where the bung hole is) sat below the level of the ally plate - so chopped it out the way was the easiest solution


Flattened out the pan and welded it back in







Almost 36 years untouched

Stripped the roof back - lots of surface rust - especially around the rear hatch hing mountings - loads of rust killer

Good thing with the shell being on its side you can pour rust killer down all the joints and holes in the roof pressings and down the inside of the front roof panel


Note the underside of the roof lip mod!!!!

Wednesday, May 06, 2009

First time in 15 years its turned a wheel – well sort of !!

Big push now on the get the tub sprayed – so time to split chassis and tub apart and put some rubber on the corners



Quite pleased with how the rear suspension geometry sits with some weight on it – solid as a rock – have got quite a bit of adjustment up and down on the upright and shock so when fully laden with tub will see what’s needed


Shell going on it side to get at all the areas I could not reach from above


Quite a bit of overspray and angle grinder crudd all over the place, a few nicks and scratches – will take little work to clean up






Got the last bit of rust out the tub as well – shell is far too good to trackday really – but do I look bothered – more solid it is less it will bend!!!!!!
Nice shot of engine and gearbox - needs a good clean up





Given the underside a really good clean up and good dose of rust kill




Inside floor pan was a bit of a disaster zone - gone a bit rusty - so again gone over with the wire brush attachement

Friday, May 01, 2009

Rear Deck Area

Started panelling in the rear deck - want to make it fire proof if nothing else

Bit of 20mm box and a flat sheet

Left a hole for removing the alloy tank

Spotted togehter and will fibreglass over all the gaps in the inner rear wing