Sunday, September 21, 2008

Aero dynamics - well sort of !!

Been wanting to look under the roof lip strip since 1987 when I did some minor repairs - which have pretty much lasted the time and saved the roof lip



On the face if it the lip was pretty good - however two minor cuts with a hacksaw and the finishing strip was off to reveal rust!!!










Most of the lip although pretty rusty is all in one piece - until it got chopped off with the grinder




Not sure about you but I've never seen a GT6 that has been de-seamed that looks right - it looks like when you cut your eye brows off - not that I've done that either

Rather than de-seaming I'm removing the lip over the majority of the screen and seam welding the roof & leaving 3 short sections so I can put the finishing strip back on - this will allow the air to flow between the it rather than around it




You can just see the gap below - hope to reduce drag around the windscreen area




Roof back to bare metal

Sunday, September 14, 2008

Body Work Continue's

I really hate body work!!!

Been working away on the brake conversion and the rear end mods

Bulkhead has been cut out the way completely along with the dash top and dash itself - going to graft a Volvo steering column in as its going to a much easier to sort all the electrics out - indicators lights and ignition






Cut the old braces out and reused so should stiffen it all up


Servo unit fits like a glove - however will need to run a remote reservoir as I would need to chop the windscreen frame out!!







Back end is on going and stating to get on my t*ts

Had to revamp the location for the wipe motor due to the servo mods - going to run a single blade NASCAR style - so plugged the original holes and washers








Monday, September 01, 2008

Breaking System Mods

Started work on the braking system - using a Subaru Impreza Turbo servo unit


Easier to cut the entrie rear bulk head panel out the way

Reshaped the top of the scuttle


Need to make a bracket then reinforce the bulkhead



Started to sus out the wiring loom - nightmare!!!!










Finished off the oil cooler as well