Tuesday, May 22, 2007

Different approach - Differential Next

Due to the fact the Volvo unit will produce some 280 lb ft torque and the standard Triumph differential is made from ice cream - thought it was best to investigate a replacement. Looked into using BMW small casing LSD's also the Datsun and Subaru which seems a very common route to go - however need to customise the casing on those - there is a guy in NZ that produces a nice looking kit though
.
Then as if by magic a mate of mine transplanting a Rover V8 into a mk2 GT6 suggested a 4x4 Cosworth diff (nice one Mike) - not really a huge fan of Ford parts but its the right ratio and its an LSD - plus many options for CV joints etc.
.
So the easiest way to go about this was to remove the existing diff mounting although this looks a bit radical its far easier to start from scratch

After some initial fitting up the diff unlike the Triumph is offset - so not sure if the Ford runs a long and short shaft - or is central/offset in the body tub. So were talking around 25mm offset from centre in the Triumph chassis - means I will need a long and short shaft - it was my intension to run the metro short shafts but strangely enough there is a difference of 24mm between the length of the Metro and MGF shafts - so problem solved.

So with the existing mounting out the way - time to fabricate some box section to mount the diff via the stock Ford rear mounting.


Simple really and a lot stronger than the standard diff mounting points





4.0mm plate for the rubber mount



Finally just need to chop a standard diff nose plate and a couple of 4mm plates to pick up on side of the Ford diff and the standard front chassis moutings points