Got some stuff back from the blasters today - one modified chassis

Fabricated engine & diff mounts and also gearbox linkage
Front and rear upper suspension arms
Dropped a couple of bushes down from the cradle with M12 bolts so should stop any movement or twist, also some 4mm plate for seat belt mounts

Due to the top arms being wide than the turrets – but just wide enough to fit outside the upright rather than chopping the arms then bending and putting smaller end bushes decided to fabricate pickups externally – just need to complete now with some minor strengthening webs etc
So having initially jigged up a complete MGF rear suspension set up - decided to bin that idea as the prospect of transferring 280 lbs ft torque through a Metro drive shaft doesn’t really inspire a great deal of confidence. 
Finished boxing around diff - also gives me good location for seat belt mounts



5 speed gearbox transplant
Removed the top inner part of the chassis on the passenger side and replaced it with 2.5mm x 60mm angle - and a smaller section on the drivers side which is twice as strong as the original box section with some additional strengthing webs
The transplate begins
The first cut was the worst - once the grinders gone through the bits that are in the way the rest is easy - no turning back now - needed to remove the chassis cross member so that the unit woud to drop the unit in - the plan was to simpley insert a new 3mm thick 75mm box section just infront of the steering rack. 
Block:
5 Cylinder Volvo 2319cc 850 T5-R
Bore 81.0mm
Stroke 90.0mm
Head:
4 Valve per cylinder
DOHC
Compression Ratio 8.5:1
Camshafts:
Standard
Power band 2000 – 5200
Induction & engine management:
Multi-portfuel injection
850-R Turbo Charger
Remapped ECU by Celtic Tuning - see links
Exhaust:
3' Straight through system without Cat
Transmission:
5 speed Volvo 960(M90) gearbox with 3.61:1 Cosworth limited slip differential
Suspension:
Front – Top and bottom tubular wishbones, Ford Sierra uprights, hubs and discs, adjustable coil over shock absorbers
Rear – Top and bottom tubular wishbones, Ford XR4x4 driveshafts, hubs and discs, adjustable coil over shock absorbers
Brakes:
Front - 280mm Ventilated discs and Granada calipers
Rear – XR4x4 Discs and Granada calipers
Power Output:
285 bhp - 280 lb/ft torque
Block:
Triumph 6 cylinder Capacity 2263cc
Bore 79.5mm
Stroke 76.0mm
Head:
Flow bench developed head
37.75mm inlet 31.25mm exhaust valves
Compression Ratio 12.75:1
Camshaft:
Specially developed full race profile
Power band 5000 – 7800
Induction system:
Modified Lucas fuel injection
6-inch Ram pipes
Exhaust:
6 – 3 tubular steel manifold into 3 separate pipes and silencers
Transmission:
Lighten flywheel, AP competition clutch, 'J' type overdrive gearbox and 3.63:1 differential
Suspension:
Front – Standard configuration, Koni shock absorbers with 9’1/2’’ coil springs 800 lbs rating
Rear – Rotoflex couplings, Koni shock absorbers with Triumph Herald estate transverse spring
Brakes:
Front - Ventilated discs with 4 pot callipers
Rear – Discs
Power Output:
200 bhp (flywheel)